What is the difference between side cutters and flush cutters?

What is the difference between side cutters and flush cutters?

The term “flush” means level or straight and on the same plane, so flush cutters cut a wire level. Side cutters or angle cutters, cut on an angle, meaning the wire edge will be cut to one side. The choice of use is totally up to you, the wire jewelry maker. This is also known as “double cutting.”

What is the difference between side cutters and diagonal cutters?

These tools tend to be durable and hard-wearing, designed for tough professional applications. One of the key differences is that diagonal cutters are often better suited to smaller, more delicate cutting tasks, whereas side cutters are ideally suited to larger-scale applications.

What is a flush cutter?

Flush-cutters – provide an unbroken, even cut to the material for a clean design look. Because the jaws are angled, both ends of the wire cannot be cut flush, only the wire on the side that is flat will be flush, the wire remnant on the angle side will have an angle or “V” cut.

Are Flush cutters wire cutters?

Flush cutters have a variety of different uses apart from cutting thin wires. They can also be used the same way you’d use pliers as a means of reaching into tight spaces to reach and hold wires.

What is another name for side cutters?

In the United Kingdom and Ireland, diagonal pliers are commonly referred to as snips or nippers, and in Canada, Australia and New Zealand they are often referred to as side cutters.

Can you sharpen wire cutters?

But if you happened to be attached to the pair you have, it’s possible to sharpen your wire cutters. The easiest way is to take a nail file and file along the blade edge of your cutters. A second option is to use a drill with a sanding strip and try to smooth over the flat sides of the cutters.

When would you use a diagonal cutter?

Diagonal cutting pliers are used for cutting wire and small pins in areas that cannot be reached by larger cutting tools. Because the cutting edges are diagonally offset about 15 degrees, these can cut objects flush with a surface.

What do you use end cutting pliers for?

End-cutting pliers – also known as nippers, are used to cut nails, wires, rivets, and bolts. Due to the almost flat head design, the user can get flush with the surface to cut the object, without digging into it.

What is the use of flush cutter?

These flush-cutting pliers allow wires to be trimmed flush or nearly flush to a solder joint, avoiding the sharp tip left by symmetrical diagonal cutters. It is common for this type of diagonal cutter to be referred to by another name, such as “flush cutter” to distinguish it from symmetrical cutters.

Can flush cutters cut metal?

Can I use a Micro-Shear® to cut sheet metal? No. Micro-Shears® Flush Cutters are not designed for cutting long surfaces of material like sheet metal. Sheet metal applies pressure the full length of the blades.

Are pliers and wire cutters the same thing?

Remember that wire strippers are best for removing the insulation from wire, while cutters are best for (you guessed it) cutting wire. Pliers help you reach, bend, grab, cut, hold and loop wire, and crimpers are the best tool to join two pieces of ductile material together.

What is the difference between side cutters and flush cutters? The term “flush” means level or straight and on the same plane, so flush cutters cut a wire level. Side cutters or angle cutters, cut on an angle, meaning the wire edge will be cut to one side. The choice of use is totally up…