Can you seal ardex feather finish?

I did two thin coats of the ardex feather finish, allowing about 10 hours to dry in between. I used a sanding block after each coat had dried. I then sealed with acrylic quikcrete cure and seal (two coats). Overall, it took me about 24 hours including dry time and 2 hours of actual work to get this done.

Can you use self leveling concrete for countertops?

In addition to flooring, self-leveling concrete is popular for concrete countertops. The product is highly fluid and pourable, reducing installation time frames. The end result is a concrete countertop with strength and low permeability. It is compatible with limestone aggregates.

Is ardex feather finish waterproof?

ARDEX FEATHER FINISH – Laminate Floors and Waterproof Flooring-Carpet-Wood-Tile-Parquet-Soundproofing-Vinyl-Porcelain in Miami Florida Talula Floors.

How long does it take for ARDEX FEATHER FINISH to dry?

Allow thorough drying to a clear, thin film (min. 3 hours, max. 24 hours). NON-POROUS SUBSTRATES: ARDEX FEATHER FINISH will bond to some non-porous substrates, such as burnished concrete, terrazzo, and ceramic and quarry tile, without the use of a primer.

Can you skim coat concrete countertops?

You may be familiar with concrete countertops that are a solid piece of concrete that’s poured in place, but skim coating is an easy option that doesn’t require any demo. If you’re a DIY-loving renter that has the “go ahead and make changes but I’m not going to pay for it” landlord, then this project is for you.

Is self-leveling concrete strong?

Self-leveling concrete creates a highly smooth surface that is also high-strength. Self-leveling concrete results in a concrete stronger than normal concrete, which means it is ideal for reinforced concrete construction. Self-leveling concrete is very unlikely to cause allergic reactions.

Does ardex feather finish expire?

The shelf life of ARDEX PC-T and ARDEX SD-T is extended to 9 months (previously 6 months) for unopened, properly stored bags. We are writing to clarify our recommendations for the installation of ARDEX products with consideration to the new OSHA Standard on crystalline silica.

How long does it take for ardex to dry?

Is ardex feather finish self leveling?

ADHESIVE RESIDUES ON CONCRETE: ARDEX FEATHER FINISH also can be installed over non-water-soluble adhesive residue on concrete only. If adhesive interaction and/or migration are a concern, install an ARDEX self- leveling material such as ARDEX K 15® Premium Self-Leveling Underlayment.

Where can I buy Ardex concrete countertops?

Ardex Feather Finish (I could only find this locally at Home Depot, but Amazon also carries it.

What kind of countertops are Ardex feather finish?

Ardex Feather finish aka Concrete Countertops. Have you heard about them? Have you been intrigued to give them a try? I’ve had these Ardex Countertops in my kitchen for the last four years, so I want to break down what they are, how they look, how they hold up, and all questions I get about them.

How long does it take to mix Ardex concrete?

Mixing the concrete is very similar to mixing thin set or grout when tiling. You just want a good peanut butter consistency. TIP: If you wait more than 20 minutes to mix a new batch, throughly clean out your bucket or get a new one.

Can you seal ardex feather finish? I did two thin coats of the ardex feather finish, allowing about 10 hours to dry in between. I used a sanding block after each coat had dried. I then sealed with acrylic quikcrete cure and seal (two coats). Overall, it took me about 24 hours including dry time…